|
TUTORIAL for SHARP:
Power ON phone
Connect phone to powered GX30 serial cable (9v)
Open GX30 unlocker and click UNLOCK
After phone reboots 2 times (displays XXXX)
Press 1 on phone keyboard, you will see Diag mode Menu,
press 99 and press right top key,
press 3 and then press right top key - wait a few seconds
press 1 and then press right top key - wait 30 seconds until
display finished writing
Now unplug cable and remove battery from phone - GX30i
UNLOCKED!!
BENQ Unlock procedure
- Connect Correct cable to BENQ phone ( BENQ cable is
not T191 )
- PHONE OFF
- Press Unlock on software
- Press Power Bouton on PHONE
- See and wait 3 secondes :)
- Unlocked !
TUTORIAL for repair O2X2 BENQ:
YOUR PHONE DONT SWICTH ON, for repair it make :
- CHARGE the batterie
- FLASH IT , using Redbox + flash 02X2 from member
- After , your phone dont switch ON,
no problem Charge him 20 minutes, you will be alive again :)
PLEASE NOTE: This software is a
“brute force code generator”. It does not use any algorithm or
confidential information which is the property of SHARP/BENQ. It
does not use any information contained in “program code”
copyrighted by SHARP/BENQ or does it access any copy-protected
areas of the handset.
|
